CT-S310II Series Service Manual
- 21 -
Remove “SA, PE SENSOR” from “BASE, HEAD SUPPORT-03”.
<Precaution at disassembly /
reassembly>
When reassembling, insert “BASE,
HEAD SUPPORT-03” into “SA, PE
SENSOR” as shown below.
7. Disassembling “SA, COVER OPEN SENSOR 2”
Remove two “SCREW, BHT (BT#3), M1.7 7” that fasten “SA, COVER OPEN SENSOR 2”.
Detach the cables from the hooks at “FRAME, MAIN-03”.
<Precaution at reassembly>
Be careful not to tighten the
screw excessively.
Check the sensor mounting
position and its orientation.
Check the cable routing
position.
<Precaution at disassembly /
reassembly>
Route the cables through the
hooks at “FRAME, MAIN-03”
and pass them through the
hole at the bottom. Be sure
to hang the cables inside the
hooks.
Bosses
Pull “BASE, HEAD SUPPORT-03” toward you while
pushing the bosses at “SA, PE SENSOR”.
Viewed from
the side
SCREW, PHT (BT#3), M1.7 7
Check the cable routing position.
To Next Page
Loading...
