Using the Alarm5.
The alarm uses a 24-hour system. Once set, an alarm sound will be emitted for 15
seconds once every day at the set time.
The alarm is emitted according to the time set in time (TME) mode. It cannot be set for
local time (L-TM).
[Setting the Alarm Time]
Rotate the crown while in its normal position 1.
to align the mode hand with alarm [ALM]
mode as indicated on the mode sub dial.
Second hand:• The hand rapid advances to
the ON or OFF position.
24-hour hand, hour hand, minute •
hand:
The move to indicate the alarm time last set.
Function hand:• Stops at the 0 position.
After adjustment of the local time, push the crown in two steps to its normal position.4.
Note:
If the hour hand passes the 12:00 midnight position, the date will be corrected by •
1 day. Be sure to pay attention to AM/PM indicated by the 24-hour sub dial when
setting the time difference.
To return the time difference to original status, return the hour hand in the opposite •
direction of the adjustment.
(2)
(A)
(B)
Setting the alarm
To Next Page
Loading...
Need help?
General
