Correct reference or 0-positions for each hand and the date
Correct reference or 0-positions are given below.
24-hour hand
: 0:00
Hour hand, minute hand
: 0:00
Second hand
: 00 seconds
Function hand
: 0 position (12:00 position)
Date
: 1st
If any of the hands or the date shows a
reference or 0-position other than given
above, perform the procedure in
“Correcting the Reference or 0-Position”.
Checking and Correcting the Reference 6.
or 0-Position of Each Hand
Before using this watch, check that its functions are working correctly as described
below.
What is a Reference or 0-Position?
The term “reference or 0-position” refers to the hand and date base positions used as a
reference for correct operation of the watch. If this position is not correctly set, the
watch will not display its functions correctly.
[Checking the Reference or 0-Position]
Rotate the crown while in its normal position to align the mode hand with 1.
chronograph [CHR] mode as shown on the mode sub dial.
Pull the crown out one ‘step’ to position 1 to set reference or 0-position confirmation 2.
(function hand and date correction mode).
The 24-hour hand, hour hand, minute hand, second hand, function hand, and date will
rapidly advance and stop at the reference or 0-positions recorded in memory.
(1)
(A)
Correcting the Reference or 0-Position
Normal
position
To Next Page
Loading...
Need help?
General
