[Correcting the Reference or 0-Position]
<Correcting Reference or 0-Positions of the Function Hand and Date>
In chronograph [CHR] mode, pull the crown out two steps to position 2 and hold down 1.
button (A) for 2 or more seconds to correct the reference or 0-positions of the function
hand and date.
Rotate the crown to the left or right to adjust the date.
2.
(1) The function hand moves 1 step at a time for each click of the crown.
(2) Quickly Rotate the crown 2 or more clicks consecutively to move the function hand 4
revolutions and advance the date by 1 day. Rotate the crown to the left or right by 1
click to stop rapid advance.
The correct reference or 0-position for the function hand is the 12:00 position •
immediately after it changes to “1”, while that for the date is the position immediately
after it changes to “1”.
After setting the date to “1”, Rotate the crown 1 click to adjust so that the function hand
points to the 12:00 position.
The correction mode changes each time the upper right button (A) is pressed while the
crown is pulled out two steps to position 2 in chronograph [CHR] mode.
Function hand
and date
24-hour hand, hour hand
and minute hand
Second
correction
(A)
(A)
(A)
Correct reference or 0-positions for each hand and the date
Correct reference or 0-positions are given below.
24-hour hand
: 0:00
Hour hand, minute hand
: 0:00
Second hand
: 00 seconds
Function hand
: 0 position (12:00 position)
Date
: 1st
If any of the hands or the date shows a
reference or 0-position other than given
above, perform the procedure given in
“Correcting the Reference or 0-Position”
(See next page).
(1)
(A)
Correcting the Reference or 0-Position
Normal
position
To Next Page
Loading...
Need help?
General
