Citizen E820 - Page 37

83
Before executing the all-reset, rst check that the watch is fully charged and that the
second hand is moving in 1-second intervals.
If the all-reset is executed while the watch is insufficiently charged, subsequent
operations will become impossible and the watch will completely stop.
1. Rotate the crown while in position 1 to align the mode hand with chronograph
[CHR] mode.
2. Pull the crown out two steps to position 2 (reference or 0-position correction
mode).
• Each hand and the date will move to their recorded reference or 0-positions
and then stop.
3. Simultaneously press and hold both the upper and lower right buttons (A) and (B)
for approximately 2 seconds, then release.
• A conrmation sound will be emitted, and then a hand movement demonstration
will be performed in order of second hand, hour hand/minute hand/24-hour hand,
and function hand/date to indicate that the all-reset has completed.
4. Press the crown into its normal position and the All Reset setting is nished.
Note
Aer the all-reset, always correct the reference or 0-positions for each hand.
en correctly adjust each mode before using the watch.