Citizen IF1-WFx4 Series - Supported Protocols Tab; User Account Tab; Maintenance Tab

4 NetToolK
44
5-3-3. “Supported Protocols“ Tab
Use the “Supported Protocols“ tab to enable
LPR and the RAW protocol, set the printer
timeout duration, enable "Priority to
Ethernet", and enable UPnP.
5-3-4. “User Account“ Tab
Use the “User Account“ tab to change the
administrator name and password.
Warning
If you forget the new username and password,
settings must be returned to the factory default
settings.
5-3-5. “Maintenance“ Tab
Use the “Maintenance“ tab to restart the
LAN interface board, return the settings to
the factory default settings, and update the
firmware.
Note
After the firmware upgrade starts, do not
disconnect power or transmission to the
printer until the upgrade is complete.