Citizen U200 - Chronograph Usage; Operating the Chronograph; Chronograph Measurement Notes

30
31
English
You can measure times up to 23 hours 59 minutes 59 seconds 99, per 1/100 seconds.
1. Press button M
repeatedly to change the
mode to [CHR].
2. Press button A to start measurement.
The measurement indicator ( ) appears.
• Each time you press button
A, the measurement starts or stops.
• Press button
B to display a split time for 10 seconds. While a split time is
displayed, the split time indicator (
) flashes.
• The measured time of the hour digit is displayed on digital display B .
3. Press button A to stop the measurement.
The measurement indicator ( )/split time indicator ( ) will disappear.
4. Press button B to reset the measurement time.
5. Press button M repeatedly to change the mode to [TME].
On measurement
• When the measured time passes
over 24 hours 00 minutes 00 seconds
00, the measurement stops and the
measured time is reset.
• Measurement continues even if [CHR] is
changed to another mode.
Using the chronograph [CHR]
Button B Button A
Button
M
Digital display B
U200_EN_final.indd 30-31 08.4.24 3:07:59 PM