Citrix ADC MPX 5550 User Manual

Citrix ADC MPX
10. If the device name s1e is not mounted, type /sbin/mount /dev/ad0s1e /var to mount the
disk drive on the /var partition. Type df to display the mounted partitions.
If the output does not appearto be normal or an error is displayed, reset the hard disk drive, and repeat
the procedure again. If the error is displayed again, contact Citrix Support for further investigation.
Migrate the configuration of an existing Citrix ADC appliance to another
Citrix ADC appliance
August 12, 2022
Before migrating to a new appliance, you must make some changes to the configuration of the old
appliance before you copy the configuration to the new appliance.
Note: The following procedure does not apply to Citrix ADC FIPS appliances.
Migrate a configuration
1. On the old appliance, create a backup copy of the configuration file (ns.conf).
2. Use a vi editor to edit the configuration file that you backed up. For example, you might want
to change the user name, host name, and password.
Note: Remove all interface-related configuration, such as set interface, bind vlan, add
channel, bind channel, and set channel.
3. Shut down the old appliance.
4. Perform initial configuration on the new appliance. Connect to the serial console, and at the
command prompt type config ns to run the Citrix ADC configuration script. Enter parameter
© 1999‒2022 Citrix Systems, Inc. All rights reserved. 206

Citrix ADC MPX 5550 Specifications

General

Brand	Citrix
Model	ADC MPX 5550
Category	Network Hardware
Language	English