182
BRAKES
DRAINING, FILLING AND BLEEDING THE BRAKING SYSTEM
Front brake caliper : Bleed screw (3).
Rear brake caliper : Bleed screw (4).
Bleed each brake cylinder, proceeding in the following sequence :
Front LH wheel.
Front RH wheel.
Rear LH wheel.
Rear RH wheel.
Bleeding the braking circuit with the bleed apparatus
Connect the bleed apparatus [1] on the brake fluid reservoir (1).
Adjust the apparatus pressure to 2 bars.
For each brake circuit:
Couple a transparent tube on the bleed screw.
Submerge the other end of the tube in a clean container.
Open the bleed screw.
Wait until the brake fluid flows out without air bubbles.
Close the bleed screw.
Remove the bleed apparatus [1].
Check the level of the brake fluid (between the « MINI » level and the «MAXI» level).
Fill if necessary with the the approved and recommended synthetic brake fluid.
B3F202CD
B3F202DD
To Next Page
Loading...
