77
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine : 8HT
Under the vehicle.
Refit the nut (17), tighten to : 6 ± 0,6 m.daN.
Refit :
- the engine speed sensor (16)
- the belt retaining stop (15), tighten to : 0,7 ± 0,1 m.daN.
- the lower timing cover (11)
Lock the engine flywheel, using tool [1].
Remove the screw (12).
Refit : the accessories drive pulley (14), the screw (12) (new).
Tighten the screw of the accessories drive pulley (12) :
- Pre-tightening : 3 ± 0,3 m.daN.
- Angular tightening : 180° ± 5°.
Remove tool [1].
Refit the exhaust clip, using tool [5].
In the engine compartment
Refit :
- the upper timing cover (5)
- the expansion chamber (8)
- the accessories drive belt (see corresponding operation)
Proceed in the reverse order to the removal operations.
Reconnect the battery negative terminal.
IMPERATIVE : Perform the operations that are required following a battery reconnection (see
corresponding operation).
B1E2005D
B1E2004D
To Next Page
Loading...
