286
CLUTCH
GEARBOX
TRANSMISSION
CLUTCH SPECIFICATIONS
Engines: HFX – KFV – KFU – NFU – 8HX – 8HW – 8HV – 8HY
NOTE: All the clutches are «push» type with hydraulic control.
Description.
The declutch control has a declutch fork mounted on a ball-joint.
(1) The ball-joint is screwed into the clutch casing.
(2) Declutch fork.
(3) Clutch casing.
(4) Bearing.
(5) Clutch plate.
The clutch control slave cylinder
(7) is fixed by two screws (6) onto the exterior of the clutch casing.
Tightening torques (m.daN).
- Fixing of clutch plate / engine flywheel : 2 ± 0,2
- Fixing of clutch control slave cylinder / clutch housing : 2 ± 0,25
- Fixing of engine flywheel / crankshaft
Pre-tightening
: 1,7 ± 0,1
Angular tightening : 70° ± 5°
B2BP047C B2BP04QC
C2 - C3 - C3 PLURIEL
To Next Page
Loading...
