287
CLUTCH
GEARBOX
TRANSMISSION
CLUTCH SPECIFICATIONS
Engines: KFW - NFU - NFV - 6FZ - RFN - RFS - 8HZ - 9HZ - 9HY - WJY - RHY - RHZ
NOTE: All the clutches are «push» type with hydraulic control.
Description.
The declutch control has a declutch fork mounted on a ball-joint.
(1) The ball-joint is screwed into the clutch casing.
(2) Declutch fork.
(3) Clutch casing.
(4) Bearing.
(5) Clutch plate.
The clutch control slave cylinder
(7) is fixed by two screws (6) onto the exterior of the clutch casing.
Tightening torques (m.daN).
- Fixing of clutch plate / engine flywheel : 2 ± 0,2
- Fixing of clutch control slave cylinder / clutch housing : 2 ± 0,25
- Fixing of engine flywheel / crankshaft
Pre-tightening
: 1,75 ± 0,1
Angular tightening : 75° ± 5°
Checking torque : 6,3 ± 2,2
B2BP047C B2BP05SC
XSARA - XSARA PICASSO
To Next Page
Loading...
