289
CLUTCH
GEARBOX
TRANSMISSION
CLUTCH CONTROLS: FEATURES / CHECKS AND ADJUSTMENTS
Engines: KFW - NFU - 6FZ - RFN - RFS - 8HX - 9HZ - 9HY - WJY - RHY - RHZ
Refitting.
Place the pedal in the high position (contact at “a”).
Attach the cable yoke on the hook of the clutch pedal.
Fit a new clip
(3).
Fit the end-piece (4) to the bulkhead (fit with G6 grease).
Clip the end-piece (5) on the gearbox.
Couple the cable to the lever
(1).
Depress the clutch cable several times to lodge the cable in place.
Check that the end-piece (4) is correctly lodged on the bulkhead.
Check the operation of the automatic adjusting system.
After fitting the cable, pull the clutch lever in the inverse direction
(direction F), the lever should
move back when pulled by hand.
Press the clutch pedal very lightly and repeat the same operation. The lever should not move
back.
WARNING: If a system blockage is detected when checking, or if the pedal has been removed,
the pedal position must be adjusted. The correct positioning of the pedal is obtained by the
angular displacement of the stop supports "a" and "b".
B2BP03CD
XSARA - XSARA PICASSO
«PUSH» clutch
«PULL» clutch
B2BP03DD
To Next Page
Loading...
