290
CLUTCH
GEARBOX
TRANSMISSION
CLUTCH CONTROLS: FEATURES / CHECKS AND ADJUSTMENTS
Engines: KFW - NFU - 6FZ - RFN - RFS - 8HX - 9HZ - 9HY - WJY - RHY - RHZ
Adjusting the pedal height.
Loosen the nut (6) and the screw (7).
Using a lever, raise the stop support (8) to its highest position. In this position, there should be a substantial free
play in the pedal.
Lower the support until there is a free play of
2 ± 1 mm.
Tighten the nut (6) and the screw (7).
Check that the clutch cable sleeve can move freely.
At rest, the clutch cable sleeve should be free and able to lengthen and shorten.
Clutch pedal travel.
The automatic clutch wear adjustment system has no manual adjustment.
Pedal travel is identical on all models:
154 ± 5 mm.
The adjustment is achieved by reducing the length of the cable sleeve.
WARNING: Automatic adjustment of the pedal travel is accompanied by a modification of the curvature of the
cable sleeve. Do not add any supplementary fixing points or alter the routing in any way.
«c» Routing of new cable.
«b» Routing after adjustment of play.
«x» Clutch wear.
B2BP03EC B2BP03FD
XSARA - XSARA PICASSO
To Next Page
Loading...
