324
CLUTCH
GEARBOX
TRANSMISSION
CHECKS AND ADJUSTMENTS: MA/5 GEARBOX CONTROLS
Engines: KFW NFU 8HZ
1 - Gear lever.
2 - Gear control bar.
3 - Engagement rod.
4 - Gear selection rod.
5 - Torque reaction rod.
6 - Gear engagement ball-joint.
7 - Fixed point on gearbox.
Adjustment.
The gear control assembly is not adjustable.
The rods do not have threaded ends.
Features.
Grease the gear engagement ball-joint.
WARNING: To secure the ball-joints, set the
gearbox control to neutral. After fitting the gear
control assembly, check that all the gears will
engage without any
”tight spot”.
B2CP27WD
XSARA
To Next Page
