CITROEN C4 PICASSO - Page 172

170
Driving
C4-Picasso-II_en_Chap04_conduite_ed01-2016
When the cruise control is paused,
it can only be reactivated when all of
thesafetyconditionsaremet.The
message"Activationnotpossible,
conditions unsuitable" is displayed while
reactivationisnotpossible.
Wait until the speed of the vehicle
isclosetothespeedsettingbefore
reactivatingthesystem-bypressing
button 2 or 3 - in order to set your
currentspeedasthenewspeedsetting.
Modification of the speed setting
Modication from the speed limit
recognition system
F The speed to be memorised is displayed in
theinstrumentpanel.
F Makeaninitialpressonbutton5;a
messageisdisplayedtoconfirmthe
memorisationrequest.
F Press button 5againtosavethesuggested
speed.
The speed is then displayed in the instrument
panelasthenewspeedsetting.
As a precaution, it is recommended that
youselectacruisespeedsettingclose
to the current speed of your vehicle, so
as to avoid any sudden acceleration or
decelerationofthevehicle.
For more information on Speed limit
recognition and its memorisation, refer to the
correspondingsection.
Enginerunningandcruisecontrolon(green),
youcanmodifythespeedsetting.
Modication from the current
speed
F By successive short presses on button 2 or
3,toraiseorlowerthesettinginstepsof+
or-1mph(km/h),
F By a maintained press on button 2 or 3,
toraiseorlowerthesettinginsteps
of+or-5mph(km/h).
Takecare:aprolongedpresson
button 2 or 3willcauseaveryquick
changeinthespeedofyourvehicle.