10
・
The driver will be damaged if the BK+ and BK- terminals of the
driver are connected directly with the electromagnetic brake.
・
If the polarity of the BK+ and BK- terminals of the driver is wrong,
the driver may be broken.
Be careful when wiring the external power supply.
・
The operating instructions for brake output (TB2) and emergency
stop input (TB3) are different. Pay extra attention when wiring
since the driver could break down if wired improperly.
・
Do not press the button forcibly when inserting or disconnecting
cables into/from the terminal block.
△
CAUTION
！
To Next Page
Loading...
