20
De-awning
On the AVERO 240 the de-awning can be carried out by operating the lever (1), by the
right hand front wheel of the machine into position (A), which in turn installs a set of
plates under the APS concave. This gives the crop an extra ‘rub’ which in turn threshes
it harder. They must only be installed when threshing is stopped.
It is recommended that these plates are only engaged when there is a difficulty in
threshing. These plates can reduce output by up to 30%.
If plates have been used make sure that the concave is clean.
Further information regarding the use of the de-awners is in the operators manual.
Stone trap
The stone trap is situated between the front elevator and the APS concave. It is
important that stone trap is emptied on a daily basis to allow for foreign objects to be
expelled before they enter the drum.
Stone Trap
Stone Trap
Pre-Separation
To Next Page
Loading...
