5.
OPERATIONS
Basic Operations
Note:
• Refer to the diagrams
in
"3.
CONTROLS"
when reading this chapter.
A CAUTION
When the
unit
is
turned on, starting and
stopping the engine with
its
volume
raised to the maximum level may harm
your
hearings.
Be careful about adjusting the volume.
Power on /
off
Notes:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you
drain the car's battery too far, you may not
be able
to
start the engine and this can
reduce the service life
of
the battery.
1.
Start the engine. The power button / knob
illumination on the unit will light up.
~
EngineON
\.?WJ
position
2.
Press the [SRC I
<!>
] button on the front
panel or the remote control to turn on the
power under standby mode. The unit goes
back to the last status after power on.
3.
Press and hold the [SRC I
<!>
] button on
the front panel
or
the remote control to
turn off the power.
Mute
Press the [MUTE] button on the remote
control to mute the volume from the unit.
Note.
.
Doing the operation above again
or
adjusting
volume will release muting.
Volume adjustment
Turn the [VOLUME] knob on the front panel
or press the [
....
,
'Y
] buttons on the remote
control.
The adjustable range
of
volume is 0
to
40.
ACAUTION·
While driving, keep the volume level at
which external sounds can be heard.
PM~ngsourceselecUon
Press [SRC I
<!>
] button on the front panel
and remote control repeatedly to choose
desired playing source.
Notes:
Playing source selection means selecting
work mode, such as DISC mode, RADIO
mode and AUX mode.
Display system time
Press the [0] button on the front panel
or
[DISP] button on the remote control
to
switch
the display information, system time and
playing source.
RESET
Note:
* When the [RESET] button is pressed,
frequencies
of
radio stations, titles, etc.
stored
in
memory are cleared.
RESET
CZ101
10
To Next Page
Loading...
Need help?
General
