Clarion CZ101 User Manual

Radio Op_e~_a_t,_·o_n_s _
Select tuner as playing source
Press [SRC I <!>] button once or more to
enter
RADIO mode.
Select one radio band
Press the [BAND] button on the panel or on
the remote control to select one radio band
among FM1, FM2, FM3 and AM.
Manual tuning
During manual tuning, the frequency will be
changed in steps.
Press the [
~ ] or [ ~] buttons on the panel
to tune in a higher / lower station.
Auto tuning
Press and hold the [ ~ ] / [ ~] buttons on
the panel
or remote control to seek a higher /
lower station.
To stop searching, repeat the operation
above
or press other buttons having radio
functions.
Note:
When a station is received, searching stops
and the station is played.
Preset scan
Preset scan receives the stations stored
in preset memory in order. This function is
useful when searching for a desired station
in memory.
1. Press the [PS/AS] button.
2. When a desired station is tuned in, press
the
[PS/AS] button again to continue
receiving that station.
Note:
Be careful not to press and hold the [PS/AS]
button for 2 seconds or longer, otherwise the
auto store function will begin and the unit
starts storing stations.
Auto store
Only stations with sufficient signal strength
will be detected and stored in the memory.
Press and hold the
[PS/AS] button (2 sec.) to
start automatic station search.
To stop auto store, press other buttons
having radio functions.
Notes:
1. After auto store, the previous stored
stations will be overwritten.
2.
The unit has 4 bands, such as FM 1, FM2,
FM3 and AM. FM3 and AM can store
by AS function. Each bands can store 6
stations, CZ101 can store 24 stations in
total.
Manual store
When one expected radio station has been
detected, press and hold
number button 1-6
to store it in the memory.
Recall the storedstations
Press one numeric button among 1 to 6 on
the panel to select the corresponding stored
station.
Local seeking
When LOCAL seeking is on, only those radio
stations with strong radio signal could be
received.
To open or close LOCAL function, press and
hold the
[0] button on the front panel, then
press [
~] button repeatedly until LO or OX
displays on the screen, rotate the [VOLUME]
knob to select Local or Distant mode.
Note:
The number of radio stations that can be
received will decrease after the local seeking
mode
ison.
CZ101 12

Clarion CZ101 Specifications

General

Brand	Clarion
Model	CZ101
Category	Car Receiver
Language	English