EasyManua.ls Logo

Clarion NZ502 - Set the Anti-Theft code

Clarion NZ502
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28 NZ502
English
English
Audio Setup Menu
Thismenuincludes:Balance,Fader,SelectEQ,Sub
WooferCtrl,SubWooferPhase,HighPassFilter,low
PassFilter,AmpCancelandMagnaBassEX.
Balance: Choose the desired volume for left and right
speaker.
Fader: Choose the desired volume for front and rear
speaker.
Select EQ:Choosethedesiredmode:BassBoost,
Impact,Excite,CustomandOFF.
Sub Woofer Ctrl:Choosethedesiredsubwoofergain
from 0 to 14.
Sub Woofer Phase: Choosethesubwooferphase
normal or reverse.
High Pass Filter: Choosethehighpasslter
through/55Hz/85Hz/120Hz.
Low Pass Filter:Choosethelowpasslter
through/62Hz/95Hz/135Hz.
Amp Cancel:Choosetheamplieraudiooutputon
or off.
Magna Bass EX: Choose the loudness on or off.
Navigation Setup Menu
Thismenuincludes:GPSTime,NaviInterrupt,and
VoiceGuidance
GPS Time: Set the system time to be synchronized
withGPSlocaltimeornot.
Navi Interrupt:Therearethreechoose:On/Popup/
Off.“On”:ThenavigationscreenwillcovertoAV
screenwhenreachingsomekeypoint.“Popup”:When
smallturninfowindowwillpopupinthetopofthe
AVscreentoindicatethekeypoint.“Off”:Turnoffthis
function.
Voice Guidance: Enable or disable the navigation
voice guidance.
Voice Guidance Mix:Therearetwochoose:On/Off.
“On”:Thenavigationvoiceguidancewillplayatthe
sametimeandthevoiceofthecurrentsource.“Off”:
Onlythenavigationvoiceguidance.(VoiceGuidance
On)
Others Setup Menu
Set password:SetthepasswordforDVDparental
control.
Parental control: Set the rating of the age. It contains
KidSafe/G/PG/PG-13/PG-R/R/NC-17/Adult.
Audio Language: Set the Language for DVD Audio.
Subtitle Language: Set the Language for DVD subtitle.
System Language: Set the Language for system
screen.
Blinking LED: SelecttheblinkingLEDOn/Off.
Screen Calibrate: The function of it is to select the TS
CalibrateYESorNO.
Factory Default: The function is to select to load
factory default or not.

Table of Contents

Related product manuals