Clarion NZ502 - Wire Connections Diagram

37NZ502
English
English
Cautions on Wiring
1.Besuretoturnthepoweroffbeforewiring.
2.Beparticularlycarefulwhereyouroutethewires.
 Keepthemwellawayfromtheengine,andexhaustpipe,etc.Heatmaydamagethewires.
3.Ifthefuseshouldblow,checktoseeifthewiringiscorrect.
 Ifafuseisblown,replaceitwithanewoneofthesameamperageratingastheoriginal(15AFUSE).
4.Toreplacethefuse,removetheoldfuseonthebackoftheunitandinsertthenewone.(Figure8)
NOTE:
There are various types of fuse holder. Do not let the battery side touch other metal parts.
Figure8
Fuse(15AFUSE)
After the connection, fix the cord by a clamp
or insulation tape for protection.
Fuseholder
CAUTION