Clarke 07012A User Manual

EN
ENGLISH
-10- Form No. 70399B Clarke
®
American Sanders Operator's Manual (EN) - EZ-8 Sander HDTR
12 grit For removing gross imperfections and restore
16 grit evenness to old fl ooring. To remove build-up of
20 grit paints and varnishes
24 grit
36 grit For the fi rst sanding of new fl ooring (maple, oak).
40 grit For removing minor imperfections and fi nishes
from old fl ooring
50 grit For fi rst sanding of new fl ooring (cedar, pine, fi r)
For clean-up of 16 grit.
60 grit For clean-up from initial cut 36 grit.
80 grit For fi nal sanding of certain hardwoods.
For clean-up of initial cuts (50 grit).
100 grit For fi nal sanding of certain hardwoods and
conifers where a smooth surface is desired.
Grain Use
Sanding Cuts and Sandpaper
Initial Cut
The purpose of the initial cut is to remove old fi nish and gross imperfections on the fl oor surface. A coarse
abrasive should be used. If the surface is severely damaged by deep scratches, pre-existing dwell marks,
uneven planks, etc., it may be necessary to sand across or diagonally to the grain to restore evenness to the
surface. If these conditions are not present, the initial cut should be done in the direction of the grain.
If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this
should occur during an initial cut, the abrasive has dulled and must be replaced.
Final Cuts
The purpose of a fi nishing cut is to remove the scratches produced during the initial cut. Use a fi ne (60 - 80
grit) grain abrasive.
If the surface remains rough after a fi nishing cut, it may be necessary to use an even fi ner grain of abrasive
(80 - 100 grit). Care should be taken in selecting the grit size of the abrasive. A very fi ne grain will close the
pores on a wood fl oor making admission of a stain diffi cult.
If glazing or burning should occur immediately into a fi nishing cut, increase pace. If it should occur during a
fi nishing cut, the abrasive has dulled and must be replaced.
8 x 18
19
/
32
Sheet 8x 19 Sleeve 8 x 18
55
/
64
Sleeve
Part No./ Cnt. Cloth Back Paper Back
Part No./Cnt. Part No./Cnt.
945390/25
945391/25
945392/25
945930/10 945416/10
945395/25
945933/10 945418/10
945397/25
945398/25 945935/10 945420/10
945399/25 945936/10 945421/10
945400/25 945937/10 945422/10

Clarke 07012A Specifications

General

Brand	Clarke
Model	07012A
Category	Sander
Language	English