7
1. Is there a minimum of 36Vdc between Pin 1 and Pin 10 at all times, unless the battery charger
is plugged into the wall outlet?
NO, is the battery charger plugged into the wall outlet? When the Charger is plugged into the
wall outlet the Charger Internal Inhibit Switch will “Open” and turn everything “OFF”. Is the
5Amp Fuse in series with the Key Switch good, otherwise check the wiring?
YES, Go to Step2.
2. Is there a minimum of 36Vdc between Pin 7 and Pin 10 with the “Key Switch” turned “ON”?
NO, check the Key Switch and wiring.
YES, Go to Step3.
3. Is there a minimum of 36Vdc between Pin 4 and Pin 10 with the “Key Switch” turned “ON”
and with the Burnisher setting on the floor in the operating position and with either one of the
Pad Switches depressed?
NO, check the Tilt Switch, Pad Switches and wiring.
Note: When the Burnisher is tilted back on the “Stops” this voltage should be 0Vdc because
“Tilt Switch” is “Open”.
YES, Go to Step4.
4. Is there a minimum of 36Vdc between Pin 9 and Pin 10 with the “Key Switch” turned “ON”
and with the Burnisher setting on the floor in the operating position and with either one of the
Pad Switches not depressed?
NO, check the Pad Solenoid and wiring.
YES, Go to Step5.
5. Is there 0Vdc between Pin 9 and Pin 10 with the “Key Switch” turned “ON” and with the
Burnisher setting on the floor in the operating position and with either one of the Pad Switches
depressed?
NO, defective 41035A Module.
To Next Page
Loading...
Need help?
General
