9
Information de Sécurité Électrique
Risque de chocs électriques. Ne pas toucher les
parties non isolées du connecteur de sortie ou les bornes non
isolées de la batterie. Toujours connecter le chargeur à une prise
de courant mise à la terre. Ne pas ouvrir ni desassembler le
chargeur – referer toute reparations aux personnes qualifiés. Pas à
l´usage des enfants.
Solid: Displays approximate scale of current output during bulk stage
Flashing: High internal charger temperature. Current output reduced.
Also displays algorithm #1
-6 for 11 seconds if no battery is connected
80% Charge (Amber)
Solid: Bulk charge phase complete, 80% charged. In absorption phase
Flashing: With no battery connected, indicates algorithm# by number of
flashes
100% Ammeter (Green)
Solid: Charging complete. Charger in maintenance Mode
Flashing: Absorption phase complete. In finish stage
AC ON (Amber)
Solid: AC Power Good
Flashing: Low AC Voltage, check voltage and extension cord (Maximum
100 ft, 12AWG)
FAULT (Red)
Flashing: Charger error. Reset charger power and refer to
Troubleshooting below
To Next Page
Loading...
Need help?
General
