16
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
• Always use a suitable holding device when cutting round or irregular
shaped timber to prevent twisting of the work piece.
CHANGING THE SAW BLADE
REMOVING THE BLADE
1. Loosen the 2 knurled screws and
remove the U shaped packer.
2. Open the upper and lower doors.
Turn the door locks clockwise to
unlock.
3. Loosen the setting knob anti-
clockwise until the bandsaw
blade has slackened.
4. Remove the old blade and
replace with a new blade (see
page 17).
WARNING: DISCONNECT THE SAW FROM THE MAINS SUPPLY BEFORE
CHANGING THE BLADE.
To Next Page
Loading...
Need help?
General
