EasyManuals Logo

Clarke Woodworker CBS250C User Manual

Clarke Woodworker CBS250C
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
FITTING A BLADE
1. Slide the new blade over the wheels, making sure the teeth point towards
the front of the saw.
NOTE: Turning the wheels as you do so makes this easier.
Centre the blade on the rubber tyres of the wheels.
2. Tighten the blade tension setting
knob clockwise until the blade no
longer slips off the bandsaw
wheels.
3. Turn the upper wheel clockwise
by hand to make sure that the
blade tracks correctly on the
wheels.
If not see “Tracking the Saw
Blade” on page 18.
4. Close and secure the doors.
5. Replace the U shaped packer.
6. Tension bandsaw blade; Align the
bandsaw blade and align the
blade guides. Run the saw for at
least one minute, stop the saw,
unplug and recheck the settings
and tension (see page 18).
WARNING: BLADES ARE NORMALLY SUPPLIED COILED, TAKE CARE WHEN
UNCOILING THE SAW BLADE AS THEY HAVE A TENDENCY TO SPRING
OPEN. WE HIGHLY RECOMMEND THAT CUT PROOF GLOVES ARE WORE
WHEN FITTING A BLADE.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clarke Woodworker CBS250C and is the answer not in the manual?

Clarke Woodworker CBS250C Specifications

General IconGeneral
BrandClarke
ModelWoodworker CBS250C
CategorySaw
LanguageEnglish

Related product manuals