CLAUSING MS1318M - Page 80

8-4!
!
Manual Lubrication Injection Device:
LIDSSOLFDEOH


















Lubrication volume indicator.
Recommend keeping the volume over 50% inside the
vessel.
!
Please take down this vessel cap to replenish the
lubrication.
For the prevention of working environment pollution,
DO NOT
replenish too much volume of lubrication while
supplying the lubrication into the vessel.
Under the circumstances of normal operation, replenish the
lubrication once every three days.
It may be adjusted the schedule of replenishing whenever
the user needs.
The main function is to lubricate the
slide rail and block
.
(The
liner guideway for saw bow
).

Fir
st 600hrs for new machine,then every 1200hrs for routine change
Replace the transmission oil after operating for
!
first 600hrs for new machine,then every
1200hrs
Recommended
gear oil
y
Shell Omala oil HD220
y
Mobil gear 630
Recommended
hydraulic oil
y
ShellTellus 32
y
Mobil DTE Oil Light Hydraulic 24
Every six months
1.Clean the filter of the cutting fluid.
2.Replace the transmission oil for every half of a year(or 1200 hours).
Check the sight gauge to ascertain the transmission level.
Recommended TRANSMISSION
OIL
y
Omala oil HD220
y
Mobil comp 632 600W Cylinder oil
3.Replace the hydraulic oil.
Recommended HYDRAULIC OIL
y
ShellTellus 32
y
Mobil DTE Oil Light Hydraulic 24
MS1318M / MS1318SA