8-5!
Gear Oil & Grease Injection Hole
1. A grease injection hole and a gear oil injection
hole on the top of gear reducer.
: The position of injection indicating.
Recommend keeping the volume under
the vessel of volume window.
˛
127(2YHU
ZLOOFDXVHRLOVSLOOLQJRXW
7RXVHWKHPDFKLQHLQDVXE]HUR
HQYLURQPHQWSOHDVHDGGDQWLIUHH]H
UHGXFHU
To unload the waste fluid:
1. Put the waste oil container in the bottom of the
reducer for unloading waste fluid
Use the wrench to ope
n the screw for unloading the
waste fluid.
Make sure the screw bolted tightly after
completed,
STORAGE CONDITIONS
Generally, this machine will be stored on the following conditions in future:
(1) Turn off the power.
(2) Ambient temperature: 5
ɗ
~ 40
ɗ
(3) Relative humidity: 30%~85% (without condensation)
(4) Atmosphere: use a plastic canvas to cover machine to avoid excessive dust, acid fume,
corrosive gases and salt.
(5) Avoid exposing to direct sunlight or heat rays which can change the environmental
temperature.
(6) Avoid exposing to abnormal vibration.
(7) Must be connected to earth.
!
MS1318M / MS1318SA
To Next Page
Loading...