16
COMMUNICATOR
®
Settings
If you want to set up a Communicator with any of the special settings shown below, press and hold the specied button
combinations during or after power up. These settings will remain in memory when the Communicators are turned off and
on again.
For Setting Press & Hold while you Press and Release the Power button
ISO restrict On A button
ISO restrict Off A and ISO buttons
Handsfree On selected button(s) A and/or B and/or ISO and ▲ volume up button
Handsfree Off selected buttons(s) A and/or B and/or ISO and ▼ volume down button
Listen-Only mode On ▼ volume down button
Listen-Only Off ▲ volume up button
WH410 only *
All-In-One Headset “lights-off” mode
B button
* NOTE: All-In-One Headsets can be set up with its indicator lights off, to avoid distraction if users are in an area visible to audience.
This setting is not saved when you power off.
For Setting With the power already on...
Increase mic gain (15 steps) Press B while you repeatedly press the ▲ volume up button
Decrease mic gain (15 steps) Press B while you repeatedly press the ▼ volume down button
BP410 only *
Increase sidetone level (5 steps)
Press A while you repeatedly press the ▲ volume up button
BP410 only *
Decrease sidetone level (5 steps)
Press A while you repeatedly press the ▼ volume down button
* NOTE: There is no sidetone adjustment function for All-In-One Headsets.
If you are not connecting a wired intercom, go on to System Operation (pg. 20).
To Next Page
Loading...
