en03d441.fm, 07.04.2011 PL12EN-1001 2011-04 45
Programming
3
Settings
Enabled Defines the level of functionality of the Part ID
• No: The Part ID interface is completely disabled. No Part ID information is present on
the Run Screen.
• Yes: The Part ID interface is enabled and is present on the Run Screen. A valid part
ID is NOT REQUIRED to run the tool. Following a rundown, the Part ID is archived
with the rundown data.
-
<Advance Serial Settings>
If you choose Yes at the drop-down menu Enabled the button <Advanced Serial
Settings> appears. It defines the serial port used to interface to the barcode
reader.
NOTE: The default port for the serial barcode interface is COM2.
Port COM1, COM2
Baud Rate 2400, 4800, 9600, 14400, 19200, 38400, 57600, 115200
Data Bits 7, 8
Parity None, Odd, Even
Stop Bits 1, 2
Flow Control None, Hardware
• Yes, interlocked: The Part ID interface is enabled, and is present on the run
screen. A valid Part ID is REQUIRED to run the tool. Following a rundown, the Part
ID is archived with the rundown data. Following either a good rundown (linking dis-
abled) or good linking sequence (linking enabled) the Part ID is invalidated and the
tool is disabled.
Part ID
Source
Defines a source of the Part ID.
• Serial port (i.e. Barcode reader)
• FieldBus
• Protocol (e.g. FEP)
• Key Input Only
• Scanner on tool
The barcode scanner on the tool is activated by pressing the start button.
- If a barcode is the condition for a rundown to be started, the barcode scanner is
activated as soon as the start button is pressed. If the barcode has been read
successfully, pressing the start button again starts the fastening sequence.
- If a barcode is not a condition to start a rundown, you can use the menu scanner
or the programmable left function key <F1> on the tool to manually activate a
read cycle. Afterwards, the barcode scanner is activated whenever the start but-
ton is pressed. If the barcode has been read successfully, pressing the start but-
ton again starts the fastening sequence. If the barcode has been read
successfully, the acoustic signal beeps for 500 ms. If the barcode cannot be read
within 3 seconds or there is an interruption by opening the start switch, the
acoustic signal emits 3 beeps in rapid succession.
Number of
Chars.
Defines the length of the Part ID, not including any termination characters which may be
sent by the barcode reader.
• 1 to 25 are valid values. Only barcodes in this length are accepted.
• 0: All barcodes are accepted without bounds checking.
Keypad
Entry
Defines whether or not a Part ID can be entered manually
• Allowed: A Part ID can be entered manually by highlighting the Part ID box on the
Run Screen and typing from the keypad or an attached keyboard.
• Disallowed: The Part ID can not be entered manually from the run screen.
To Next Page
Loading...
Need help?
General
