Clevertouch CTL-55DS4KV - Page 39

English - 38 -
GENERAL DISPLAY COMMANDS
Command Description Parameter Return
Led
󰀨
(Used for setting the led
statu of current state)
󰀨
Led is ON
or
Led is OFF
GETLED
󰀨
(Used for getting the led
statu of current state)
no parameter
#*LED is on
or
󰀨
SETSTANDBYLED Set Standby led status 
#*Standby Led is set to ON
or
#*Standby Led is set to OFF
or
#*Standby Led is not set (invalid
input)
SETRC
Enables/disables remote
control commands.

= OFF)
set remote state to ON
or
set remote state to OFF
or
Missing remote state selection
or
wrong string parameter for remote
state
GETRC
Get remote control
commands enabled
status
no parameter
#*remote state is on
or
󰀨
irkey irkey KeyValue(HEX).
string-integer n (ex: irkey
0x38)
GenericIRKeySet key: n
SETSOURCE
Set source as enable/
disable.









0(disable))
#*Selected source n
#*Enable/Disable state : b
GETSOURCE Gets source. no parameter #*source is ...
CHILDLOCK Set child lock mode. 󰀨 #*set child lock state to n
OSDMENU Set osd menu mode 󰀨 #*set osd menu state to n
AUTOTVOFF 󰀨 󰀨
󰀨
or
󰀨
GETAUTOTVOFF 󰀨 no parameter
󰀨
or
󰀨󰀨
GETCOUNTRY
Get country in channels
state.
no parameter #*COUNTRY IS : ...
GETCURRENTANALOG-
TVSYSTEM
Get current analog tv
system value.
no parameter #*CURRENT TV SYSTEM : ...
GETSWVERSION
Returns the software
version of panel.
no parameter #*V...
BUILDINFO Reports the build info. no parameter #*Build info = ... Revision = ...