Clevertouch CTL-55DS4KV - Page 40

English - 39 -
FACTORY
Load factory settings to
NVRAM.
Settings are updated with
defaults.

no parameter
#*Factory Settings were loaded to
NVRAM.
KEY Send key.


.....ext.)
n key sent
RESET Reset the device. no parameter
Reset process was successfully
accomplished. You need to
establish the connection again.
KEY standby
Switch box to Standby
mode. ( For quick
standby)
no parameter standby key sent
SETQUICKSTANDBY
(only hotel tv project)
SETQUICKSTANDBY
󰀨
on).

= OFF)
#*Set Quick Standby on
or
󰀨
or
#*Quick Standby is not enabled
GETQUICKSTANDBY
(only hotel tv project)
Returns Quick Standby
󰀨
no parameter #*Quick Stanby is n
SETQUICKSTANDBY-
OPTION
SETQUICKSTANDBY-



= OFF)
#*Set Quick Standby option ON
or
#*Set Quick Standby option OFF
or
#*Quick Standby option is ON or
OFF
or
#*Quick Standby Control is not
enabled
GETQUICKSTANDBY-
OPTION
Returns Quick Standby
option state (enabled or
disabled)
no parameter #*quick standby option is ...
STANDBY
(only hotel tv project)
Switch box to Standby
mode.
( Attention: Television
cannot be opened with
standby command.
You should open it with
remote control.
If you use STANDBY

need to establish the
connection again.
Tv state :HARD-
STANDBY )
no parameter
#*enterLowPowerMode() returns
successfully.
or
#*enterLowPowerMode() returns
unsuccessfully!
or
#*enterStandbyMode() returns
successfully.
or
#*enterStandbyMode() returns
unsuccessfully!
USBSWUPDATE
Updates software from
usb and re-boots.
no parameter
upgradeSoftwareFromUSB
(frost_bool force:1)
Successfully written
or
no ... found
USBOPERATIONS Perform USB Operations no parameter

Bank 1 etc. Be sure or observe

will be writen... This may take over
10 minutes.