English - 44 -
ENTERACTIVESTANDBY
Enter active standby
state
no parameter
#*TV will be sent to Active Standby
state!
or
#*TV is in Active Standby state
already!
EXITACTIVESTANDBY Exit active standby state no parameter
#* TV is not in Active Standby
state!
SWOL Set Wake on Lan option
0 (disable))
#*Wake on Lan is set to enable.
or
#*Wake on Lan is set to disable.
GWOL Get Wake on Lan option no parameter
#*Wake on Lan is enable.
or
#*Wake on Lan is disable.
SETCUSTOMERNAME
Change or set the
Customer name
string - (customername)
#*Customer name is set as
TOSHIBA (ie. TOSHIBA)
GETCUSTOMER Get the Customer name no parameter
*Customer:TOSHIBA#* (ie.
TOSHIBA)
screen_capture_usb
as bmp to USB stick.
and OSD)
#*Screen capture is successfull.
or
#*Screen capture failed!
NETWORK COMMANDS
Command Description Parameter Return
set_IP_address
Set static IP address of
eth0 network interface.
str-int n Example: set_IP_
address 192.168.0.15
#*IP address setting Succesfull
or
#*IP address setting NOK
get_IP_address
Get IP address of eth0
network interface. Usage:
get_IP_address
no parameter #*IPaddr: ...
SAVEWIFIPROFILE
Save access point to
or
maximum number to be stored.
checks if given SSID
returns Pass or Fail.
Works only in portal
mode
str-int ssid
#*Pass
or
#*FAIL
GETWIFIAPSSID
returns the SSID of
access point
no parameter
(<SSID>)
SETWIFIAPSSID
sets the SSID of access
point. SSID must be
maximum 32 characters
string n (example ‘AP-
#*Error! SSID can not be changed
when Access Point is active
or
#*Error! SSID parameter is too
long. Should be less than 32
characters
or
(<SSID>)
or
succeeded
GETWIFIAPSECURITY-
TYPE
returns the security type
of access point
no parameter
type is (<TYPE>)
To Next Page
Loading...
