Clevo W210CUQ - Removing the System Memory (RAM)

Disassembly
2 - 6 Removing the System Memory (RAM)
2.Disassembly
Removing the System Memory (RAM)
The computer has one memory socket for 200 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
DDR3 1066/1333MHz Memory (real operation frequency of memory depends on FSB of processor). The main memory
can be expanded up to 2GB. The SO-DIMM modules supported are 1024MB, and 2048MB and DDRIII Modules. The
total memory size is automatically detected by the POST routine once you turn on your computer.
Note: Atom™ N2600 Processors Only Support Up to 2GB of Memory
Memory Upgrade Process
1. Turn off the computer, remove the battery (page 2 - 5).
2. Locate the component bay cover , and remove screw (Figure 2a
).
3. Carefully lift the component bay cover
up (Figure 2b).
Figure 2
RAM Module
Removal
a. Remove the screw.
b. Lift the bay cover
up.

Contact Warning
Be careful not to touch
the metal pins on the
module’s connecting
edge. Even the clean-
est hands have oils
which can attract parti-
cles, and degrade the
module’s perfor-
mance.
1
2
1

1. Component Bay Co-
ver
•1 Screw
2
a.
b.
1
1
www.Teknisi-Indonesia.com