User Setup: Service Filter
24
These setup steps allow the user to monitor FAN runtimes and program
service alerts. Service alerts appear on the display. If the thermostat is joined
to a Skyport account, then the user may be alerted by Skyport Cloud Services
when to change the filter.
Runtime hours
or days appear in
the clock display.
Press and hold OVERRIDE for 2
seconds to clear reset runtime.
Service Filter Runtime (Setup Steps 22-25)
View Filter Runtime (Setup Step 22) - This
counter keeps track of the number of hours
of fan runtime in the Heating mode, Cooling
mode, and in stand alone Fan operation. Press
OVERRIDE for 2 seconds to reset.
View Filter Runtime (Setup Step 23) - This
counter displays the total number of calendar
days that have elapsed since the counter was
reset to help the user track Fan runtime. Press
OVERRIDE for 2 seconds to reset.
Service Filter Alert Hours (Setup Step 24) - This
timer allows the user to specify the number
of hours the fan will run before the “Replace
Filter” alert will be displayed. Press DOWN
continuously until OFF is displayed to disable
this alert.
Service Filter Alert Days (Setup Step 25) - This
timer allows the user to specify the number
of calendar days that will elapse before the
“Replace Filter” alert will be displayed. Press
DOWN continuously until OFF is displayed to
disable this feature.
OVERRIDE
To Next Page
Loading...
Need help?
General
