Programming a Daily Schedule
33
Adjust the Unoccupied Heat Setpoint – Press the UP or DOWN
button to adjust the Heating setpoint for times when the thermostat
is in Unoccupied. Press MODE.
The following steps determine when the Occupied period(s)
will be active.
Enable Occupied 1 – Press the UP or DOWN button to enable (On) or
to disable (Off) Occupied 1 on Monday. Press MODE.
Adjust the Start Time for Occupied 1 – Press the UP or DOWN button
to adjust the start time for Occupied 1 on Monday. Press MODE
Adjust the Stop Time for Occupied 1 – Press the Warmer or Cooler
button to adjust the stop time for Occupied 1 on Monday.
Upon pressing MODE after the above step, you will be prompted to
Save and Exit or Copy this Occupied schedule to another day.
To save and exit – Press the MODE and UP button.
To Copy Monday’s settings/schedule to Tuesday – Press Up
and then MODE. Press MODE again to copy the Monday
Settings/schedule to subsequent days.
To Program Another Day – Press MODE and then press the
UP or DOWN button to select the day to program. Repeat the
above steps for each day you would like to program.
Press and hold the MODE and UP Buttons to exit Time Period
Programming at any time.
(continued)
To Next Page
Loading...
Need help?
General
