10
EVH-X SPACE 2.1 - 12.1
M0SM10N17-03
Delivery control
Before accepting the delivery you have to check:
• That the unit hasn’t been damaged during
transport.
• Check that the materials delivered correspond
with that indicated on the transport document
comparing the data with the identification label
positioned on the packaging.
In case of damage or anomaly:
• Write down on the transport document the
damage you found and quote this sentence:
"Conditional acceptance — clear evidence of
deficiencies/damages during transport".
• Contact supplier and the carrier by fax and
registered mail with advice of receipt.
Any disputes must be made within the 8 days
following the delivery. Complaints after this
period are invalid.
Handling
Check that all handling equipment complies with
the local safety regulations (cranes, forklift
trucks, ropes, hooks, etc.).
Provide personnel with personal protective
equipment appropriate for the situation, such as
hard hat, gloves, safety shoes, etc.
Follow all safety procedures to ensure the
safety of personnel and materials.
1 Verify unit weight and handling equipment lifting
capacity.
2 Identify critical points during handling
(disconnected routes, flights, steps, doors).
3 Suitably protect the unit to prevent damage.
4 Insert the forks as shown in the figure.
In case of lifting of more units at the same
time, an appropriate container must be used.
It is forbidden to lift simultaneously more
packages letting them looses.
3 RICEPTION
A
30°
Storing
Observe external packing instructions.
Keep the unit in a dry place.
Particularl:
minimum room temperature -10°C (possible
damage to components)
maximum room temperature +50°C (possible
opening of the pressure relief valves)
maximum relative humidity 95% (possible damage
to electrical components)
Packing removing
Be careful not to damage the unit.
Recycle and dispose of packing material in
conformity with local regulations.
Size X y
2.1 3.1 530 710
5.1 7.1 640 920
10.1 12.1 NO - CLOSED 1360
To Next Page
Loading...
Need help?
General
