CMC S19 - Monthly Maintenance Schedule (or Every 120 Hours); Three-Month Maintenance Schedule (or 300 hrs); Maintenance After Initial 400 Hours

MAN. 126 rev.4 Use and maintenance manual S19 59 of 77
6.3 

 Monthly maintenance schedule (or every
120 hours) 


Opera
tions
Service by
Grease pins and movable parts
USER / CMC
Wash equipment
USER / CMC
Check
tightness and torque of turret rotation
bearing fasteners, hydraulic rotation motor
fasteners and frame. Torque as necessary.
USER / CMC
6.4 

 Three-month maintenance schedule (or
300hrs)


Opera
tions
Service by
Check
tightness and torque of turret rotation
bearing fasteners, hydraulic rotation motor
fasteners and frame. Torque as necessary.
USER / CMC
6.5 

 Maintenance after initial 400 hours 
 

Opera
tions
Service by
Replace
hydraulic filters
USER / CMC
Adjust any play on telescopic booms. Adjust and
torque to proper settings and clearances.
CMC
6.6 

 Every six-months maintenance schedule
(or every 750 hours) whichever comes first


PROCEDU
RE
Service by
Replace hydraulic filters
(25micron
)
USER / CMC
Service should be performed at this time,
including replacing hydraulic filters, greasing all
grease points, service engine, clean and wash
machine free of debris and grease. Check for
loose hydraulic fittings and tighten as necessary,
replace any damaged O rings. For record keeping
purposes, inspection report notes should be
noted inprovided area of the owner’s manual.
USER / CMC