CNC 6040 Router / Engraver System
CNCDIY CNC Routing Machines System User’s Manual
41
Step 2 Axis Test
Please the “Test this axis” button at the top right hand comer.
You can enter any value for each item to test the response of each axis
You can check the “Run” button to start the testing.
Step 3 Select your new configuration
Select the suitable configuration for your system.
Check the “OK” to start the EMC2! For more operation details of EMC2, please go to the
original website: http://www.linuxcnc.org/
To Next Page