CO/Tech FT-0205 - Display Backlight Control; Alarm Configuration

19
ENGLISH
Display backlight
Press [ SNOOZE/LIGHT ] to activate thedisplay backlight.
Thelight will come on for 5 seconds.
Continuous backlight
1. Hold in thebutton for 2 seconds. Thebacklight will come on and LED ON will
appear on thedisplay.
2. Hold in thebutton again to switch thebacklightoff. LEDOFF will show on
thedisplay.
• If theindoor unit is running on battery power, thebacklight is automatically
switched off after 30 minutes to savepower.
• When thebacklight is set to be on continuously, it can be dimmed by pressing
[ SNOOZE/LIGHT ]. BRIGHT 1 will appear on thedisplay. Pressthebutton once
more to return to theset brightnesslevel.
Adjusting the brightness
1. Press [ SNOOZE/LIGHT ] twice. “BRIGHT” appears on thedisplay and theset
brightness level willflash.
2. Press [ CHANNEL/+ ] or [ HISTORY/- ] to change thebrightness from 1 (dimmest) to
8 (brightest). Confirm your selection by pressing [ MODE/SET ].
For additional backlight settings, refer to theSettings/adjustments section.
Alarm
The weather station can be set to sound analarm if thesensors measure
weather conditions outside set limits.
When analarm sounds theweather station will emit anaudible signal and
thealarm symbol next to thedata that is outside of thelimits willflash.
The sound of thealarm can be switched off if only visible alerts are desired.
Referto theSound settings for buttons and alarms section.
Viewing the set limits
1. In normal display mode, hold in [ MAX/MIN/ALARM ] for 3 seconds to enter
thealarmmode. “HI” will be shown together with theset maxvalue.
2. Press [ MAX/MIN/ALARM ] to display theset minvalue. “LOW” is shown on
thedisplay.
3. Press [ SNOOZE/LIGHT ] or wait 30 seconds to return to normal displaymode.
When viewing thecurrent set limits, press [ MODE/SET ] to change thedisplay mode
between relative (REL) or absolute (ABS) atmospheric pressure and 1 hour (1h) or
24 hours (24h) rainfall.