EasyManua.ls Logo

CO/Tech FT-0205 - Troubleshooting Guide

CO/Tech FT-0205
156 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
ENGLISH
Troubleshooting guide
The outdoor unit sensors
send no data to
theindoorunit.
“--.-” is displayed.
When theindoor unit has lost contact with asensor
“--.-” or “--” will appear on thedisplay.
To scan for thesensors: Hold in [ CHANNEL/+ ] for
3 seconds. The symbol will show while scanning
takesplace.
Check thedistance between theindoor and
outdoorunit. Theyshould be1.5–30 mapart.
Try placing theoutdoor unit higherup.
Check that theoutdoor unit LED indicator flashes
every 16 seconds.
Insert new batteries into theoutdoorunit. Lithium
batteries are recommended for use in cold climates.
Check thebatteries in theindoor unit are not
discharged. Evenif theindoor unit runs off
themains, discharged batteries may cause
problems detecting theoutdoorunit.
Make sure that thewireless signal is not disrupted
by nearby metal structures.
Move theindoor unit away from other electronic
devices such as routers, computers and TVsets.
The temperature/humidity
readings of theindoor and
outdoor units are different
when they are placed
beside eachother.
Let thesensors stabilise for anhour. Thetemperature
readings should not differ more than 1 °C (accuracy
±0.5 °C) and thehumidity readings should not differ by
more than 6 % (accuracy ±3 %).
Adjust thevalues in theindoor unit, refer to
theCalibration section.
Poor display contrast. Insert new batteries into theunit.
The display shows rain
even when it is not raining.
Make sure that theoutdoor unit is securely mounted.
Iftheunit is not rigidly mounted, e.g. isattached to
aloose mast pole, it may send erroneous readings.
Responsible disposal
This symbol indicates that theproduct should not be disposed of with
general householdwaste. Thisapplies throughout theentireEU. Inor-
der to prevent any harm to theenvironment or health hazards caused
by incorrect waste disposal, theproduct must be handed in for recy-
cling so that thematerial can be disposed of in aresponsible manner.
Whenrecycling your product, take it to your local collection facility or
contact theplace of purchase. Theywill ensure that theproduct is
disposed of in anenvironmentally sound manner.

Table of Contents

Related product manuals