CO/Tech FT-0205 - Calibration Procedures

21
ENGLISH
Snooze
• When thealarm sounds, press [ SNOOZE/LIGHT ] to temporarily mute thealarm
for 5 minutes. Thealarm symbol will continue toflash.
• To silence thealarm permanently, press one of these buttons; [ CHANNEL/+ ] ,
[ MODE/SET ], [ MAX/MIN/ALARM ] or [ HISTORY/- ].
Calibration
• If theweather station sensors provide incorrect readings they can be adjusted.
Inorder to be able to calibrate thesensors precisely you will need to have
reference readings from sensors or instruments that you know provide you with
accurate readings.
• Relative humidity readings are always in therange of 10–99 %. Theweather
station cannot be adjusted to accept readings outside thisrange.
1. Press [ CHANNEL/+ ] or [ HISTORY/- ] to increase or decrease theselected value
respectively. Holding in thebutton for 3 seconds will change thevalue quicker.
2. Press [ MAX/MIN/ALARM ] to reset theadjusted value tozero.
3. To finish thecalibration and return to normal display mode, press [ SNOOZE/LIGHT ]
or wait for 30 seconds.
Temperature
1. In normal display mode, press and hold in [ MODE/SET ] and [ CHANNEL/+ ] at
thesame time for about 5 seconds to enter thecalibrationmode. Theindoor
temperature reading will start toflash.
2. Adjust thevalue to your referencevalue. Thevalue can only be adjusted in
increments of0.1 °C. Confirm using [ SET/MODE ].
3. The outdoor temperature reading will start toflash. Adjust thevalues in
thesame way as in point2.
Relative humidity
1. In normal display mode, press and hold in [ MODE/SET ] and [ HISTORY/- ] at
thesame time for about 5 seconds to enter thecalibrationmode. Theindoor
humidity reading will start toflash.
2. Adjust thevalue to your referencevalue. Thevalue can be adjusted in increments
of 1 %. Confirm using [ SET/MODE ].
3. The outdoor humidity reading will start toflash. Adjust thevalues in thesame way
as in point2.