Coban GPS303F - TCP; UDP Switch; Configure Parameters by USB; GPRS Setting; Setting up APN

-8”.
6.33 TCP / UDP Switch
Send command: "gprs+password,0,0" switch back to TCP mode, this is
the default mode.
Send command:"gprs+password,1,1" switch to UDP mode.
6.34 Configure parameters by USB
Connect the gps tracker to computer with the optional USB cable, open gps tracker’s flash
drive and then open with notepad to operates according the tips.
Note: Correct password is necessary every time to succeed in configuring the settings.
Note: Correct password is need every time you configure the tracker.
6.35 GPRS setting
User must send SMS via cell phone to set up IP, port and APN before
starting GPRS.
6.35.1 Setting up APN
6.35.1.1 APN standards for Access Point Name and differs from country
to country. For more information about the local APN, inquire with your
local GPRS network operator.
6.35.1.2 Text the tracker a SMS “APN+password + Space + your local
APN” via a cell phone and if succeeded in setup, the tracker will return
the message “APN OK”.