6.35.3.2 e.g, Send SMS command “adminip123456 202.104.150.75 9000”
to the tracker device, If succeeded, “adminip OK” is returned by the
device in SMS.( 123456 is default password，202.104.150.75 is IP，9000
is port).
6.35.4 Switch to GPRS mode
6.35.1 The default mode is “SMS”
6.35.2 Send SMS “GPRS+password” to the unit, and it will reply “GPRS
ok!” it means tracker device has switched to “GPRS” mode.
6.35.3 Send SMS “SMS+password” to the unit, it will reply “SMS ok!”
and restore to “SMS” mode.
6.36 Activate "Fuel" value in GPRS data
The default format of GPRS data doesn't include "Fuel" value,if you
need "Fuel"value, please send protocol+password 18 to tracker, if
succeed, it wil reply "protocol 18 ok"; send protocol+password 12 to
change back to default mode, if succeed, it will reply "protocol 12 ok".
6.37 Less GPRS traffic
6.37.1 Tracker will change to less GPRS traffic mode after parking 5
minutes, GPRS disconnect and connect again when alarm being triggered
or vehicle starts driving.
To Next Page
Loading...
