Need help?Do you have a question about the COBHAM AVIATOR 200S and is the answer not in the manual?
Defines the manual's objective: to provide installation information for the AVIATOR 200S system.
Outlines the structure of the Installation Manual, detailing chapter contents.
Explains symbols for warnings, cautions, and notes, and provides general safety precautions.
Provides an overview of the AVIATOR 200S System, its components, and services.
Lists the part numbers for system components, circuit breakers, and connectors.
Presents outline drawings for the SDU-5045 Compact Satellite Data Unit.
Provides outline drawings for the SCM-5055 SDU Configuration Module.
Shows outline drawings for the LGA-5005 HLD/Enhanced Low Gain Antenna.
Covers general considerations and system components for installing the AVIATOR 200S.
Provides guidelines for mounting CSDU, SCM, and HELGA, including ground bonding.
Details electrical installation, wiring diagrams, and pinouts for system components.
Lists recommended cables and allowed lengths for power, RF, ARINC 429, Ethernet, and discrete signals.
Outlines procedures for verifying the correct installation of the AVIATOR 200S system.
Describes the process of activating airtime services, including ID numbers and USIM cards.
Details the process of uploading system software image and configuration files.
Provides steps to verify system readiness after installation and software upload.
Presents the sequence of checks: Pre-Installation, Configuration, Ground Test, Interference Test, Airborne Test.
Checklist for verifying installation before inserting LRUs, covering connections and circuit breakers.
Provides a checklist for functional testing of the system on the ground.
Explains how to perform an interference test to ensure avionics compatibility.
Details the checklist for performing functional tests with the aircraft airborne.
Covers maintenance requirements, instructions, and scheduled tasks for continued airworthiness.
Describes procedures for removing and re-installing Line Replaceable Units (LRUs).
Provides guidance on troubleshooting system issues using status signalling and log files.
Lists detailed specifications for the SDU-5045 Compact Satellite Data Unit.
Lists detailed specifications for the SCM-5055 Configuration Module.
Lists and explains Built-In Test Equipment (BITE) error codes for the AVIATOR 200S system.
Details the DO-160G environmental conditions and test categories for the CSDU.
Lists applicable industry standards and regulatory documents referenced in the manual.
To Next Page
General