98-145168-A 1-1
Chapter 1
1111
About this manual 1
1.1 Purpose
The purpose of this manual is to provide information for installation of the AVIATOR 200S
system.
1.2 Organization
The chapters of this Installation Manual have the following information:
• Introduction
An overview of the AVIATOR 200S system and services.
• Equipment drawings
Outline drawings of the units, trays and connectors of the AVIATOR 200S system.
• Installation
Wiring drawings, installation instructions and wiring requirements.
• Configuration
A description of how to set up the AVIATOR 200S system.
• Verification with check procedures.
An overview of the recommended check procedures and checklists.
• Service and maintenance
Service information, initial troubleshooting
• Appendices
Equipment specifications, DO-160 Forms, list of error messages (BITE) and a list of
applicable standards.
The information, drawings and wiring diagrams contained in this manual are
intended as a reference for engineering planning only. The drawings and
wiring diagrams contained herein do not represent any specific Supplemental
Type Certificate (STC). It is the installer's responsibility to compose
installation drawings specific to the aircraft. This manual and the drawings
and wiring diagrams contained herein may not be used as a substitute for an
STC package.
To Next Page
Loading...
General