Chapter 4: Setup and verification
System app 21
44444
Setup and verification
Network
Network Description
RSTP Enable Enables RSTP (Rapid Spanning Tree Protocol) used for
networks with redundancy - i.e. a ring topology. (Default:
enabled)
RSTP Priority RSTP priority defines which device on a network that is in
charge of the ring. If RSTP is set to enable you select one
of the predefined values for RSTP Priority for the Control
Panel in an RSTP network.
Do not change the default value unless requested
to do so by other equipment manuals.
DHCP Enable Check this in a system with a DHCP server present
(Default: enabled). If no DHCP server is found, the Control
Panel uses zero conf to acquire an IP address or you can
set a static IP address. Tap the field and enter the value,
tap Apply.
• IP Address
• Netmask
• DNS Address
• Gateway Address
To Next Page
Loading...