Page 27For technical questions, please call 1-888-866-5797.Item 63890
PTZ Setup & Control
Note: This menu allows you to configure the PTZ
(Pan-Tilt-Zoom) settings for the dome camera.
Figure BA
1. Channel: Choose a channel with a
dome camera connected.
2. Protocol: Choose the communication protocol
between the PTZ-capable camera and DVR. If
your camera has UTC (Up the Coax) function, you
can choose COAX1 or 2 to display your camera
OSD menu or control the UTC PTZ function.
3. Baudrate: The speed of the information sent
from the DVR to the PTZ-capable camera.
Make sure it matches the compatibility
level of your PTZ-capable camera.
4. DataBit / StopBit: The information between
the DVR and PTZ-capable camera is sent in
individual packages. The DataBit indicates the
number of bits sent, while the EndBit indicates
the end of the package and the beginning of
the next (information) package. The available
parameters for DataBit are: 8, 7, 6, 5. The
available parameters for the StopBit are 1 or 2.
5. Parity: For error check. See the documentation of
your PTZ-capable camera, to configure this setting.
6. Cruise: Enable to allow to use the Cruise
mode. In order to use the Cruise mode,
set a number of preset points.
7. Address: Set the command address of the PTZ
system. Please note that each PTZ-capable camera
needs a unique address to function properly.
PTZ Control
Note: After finishing PTZ setup, you can use the
PTZ function to control your PTZ camera.
1. Click any channel on the Live Viewing screen
to open Camera Quick Toolbar, and click
the PTZ control icon. See Figure BB.
Figure BB
2. The PTZ control panel will be displayed.
See Figure BC. Click to activate
PRESET points setup page.
Figure BC
To Next Page
Loading...
