Cobra 63890 - System

Page 28 For technical questions, please call 1-888-866-5797. Item 63890
Cloud Storage
Note: This menu allows you to see what is
happening on your camera at any given time.
Uploading the snapshots can be based on a
time interval or when motion is detected.
Figure BD
Cloud Storage: Enable to allow cloud settings.
Cloud Type: Only Dropbox cloud
storage is supported currently.
Channel: Select the channels where you want
to upload the snapshots to Dropbox.
Time trigger: Set the image uploading interval. Set
OFF if you want to use motion baseduploading.
Motion Detection: Enable if you want to upload
snapshots to Dropbox when the camera detects a motion.
Drive Name: Enter the cloud storage name for your DVR.
Activate Cloud: Click to activate the cloud
function. An activation email will be sent
to the Receiver email account.
Advanced E-mail Setup: Click to
configure your email settings.
Upgrade Cloud Storage: Click to upgrade
the current cloud storage service.
To start uploading snapshots:
1. Enable Cloud Storage and configure
Cloud settings for channel(s).
2. Configure advanced e-mail settings
in Advanced E-mail Setup.
3. Click Activate Cloud and wait for
the verification email.
4. Click Activate Cloud in Dropbox
link on verification email.
NOTE: Make sure to check your email and follow the link
to complete cloud storage activationwithin 3 minutes.
5. Enter your Dropbox account credentials.
Setup of the Cloud service is now complete. If you
encountered any problems while activating the
Cloud service, please repeat steps from 3 to 5.
System
General
Figure BE
Date/Time: Enter the date and time manually.
Note: For date/time automation over
the Internet, enable NTP.
Date Format: Set the date format here.
Time Format: Set the time format here.
Language: Choose the OSD language.
Video Format: Choose video format between
NTSC and PAL. If picture is flickering or has
only black screen, format may be incorrect.
Menu Timeouts: Set the time that the DVR will
exit the menus when they are not in use.
Mode: DVR. This mode will
focus on basic analog cameras.
Show Wizard: Check if you want the Startup Wizard
to reappear each time you start up the DVR.